Kenmore refrigerator repair
Kenmore Refrigerator Repair in San Antonio
Diagnosis and repair for Kenmore refrigerators in homes, rentals and businesses across San Antonio.
Call or use the form, and we'll offer you the earliest appointment we have.
Two short steps: the appliance, then how to reach you. We'll contact you to arrange the visit.
Independent repair, not a factory service center
TrueFix San Antonio is an independent repair company, not a Kenmore service center. If your refrigerator is still under the manufacturer's warranty, contact Kenmore first, since warranty work normally has to go through their own service network.
How a Repair Visit Works
Call or Book Online
Tell us the appliance, the brand, the model number if you have it, and what it's doing.
On-Site Diagnosis
A technician finds the fault on site before any price is discussed.
You Approve the Price
You get the price first. If the repair isn't worth it for your appliance, we tell you.
Repair & Test
We make the repair, test the appliance and show you what failed.
Kenmore refrigerator repair: what to know
Kenmore refrigerators have come from several makers, and the model-number prefix tells which. A 106 is Whirlpool-built, 795 is LG-built and 253 is Frigidaire-built, and each family has its own weak points. Whirlpool-built units often fail at defrost parts and evaporator fans, LG-built French-door models at ice makers and fan motors, and Frigidaire-built ones at defrost and fan parts too. Parts come from the original platform, so the Kenmore model number drives every part choice.
Worth knowing about Kenmore: Kenmore never built its own appliances; Sears sold models made by Whirlpool, LG, Frigidaire, GE and others, and the digits before the decimal point in a Kenmore model number name the maker. Also, without the model number there is no way to tell whose engineering sits behind a Kenmore badge, or which parts will fit it.
Common Kenmore refrigerator failures
These are the failure points to check first on a Kenmore refrigerator:
- Ice maker faults on LG-built French-door models
- Defrost heater or thermostat on Whirlpool-built units
- Evaporator fan motor stopped by frost
- Water inlet valve scaled by hard water
- Start relay failing on older compressors
A list like this points the diagnosis in the right direction, but one symptom can come from parts at very different prices, so the cause is confirmed at your home before you get a quote.
How we diagnose a Kenmore refrigerator
Whatever the brand, on a refrigerator we check air circulation, then defrost, and the sealed refrigeration system last — a coil frozen solid because the defrost heater quit and a compressor that has actually failed produce the same warm refrigerator, and one costs a fraction of the other.
One refrigerator symptom that's easy to misread is a warm refrigerator section above a freezer that still feels fine, which looks like half the appliance dying but most often comes down to an evaporator fan that stopped or an air passage blocked with frost.
What Kenmore refrigerator repairs usually involve
Parts for Kenmore are made in volume and stocked by many suppliers. On a Kenmore refrigerator, the parts that wear out are mostly inexpensive ones: fan motors, defrost heaters and thermostats, temperature sensors, door gaskets, water inlet valves and ice makers.
The bill changes when the fault is a main control board or the sealed system (the compressor and refrigerant circuit). On a newer unit that can still be a sensible repair; on one well into its working life, it's often the point where replacing makes more sense, and you'll hear that at the diagnosis.
Before the visit
The model and serial number are on a sticker inside the fresh-food compartment, usually on a side wall near the top or behind the crisper drawers. A photo of that label is the most useful thing you can send when you book: it tells us which Kenmore platform you have and which parts to bring.
Make sure the vents inside aren't blocked by food, both doors close and seal, and the condenser coils at the bottom or back aren't matted with dust. If the refrigerator is in a garage, note how hot it gets out there.
In San Antonio, keep in mind garage refrigerators running through San Antonio summers at or past the hottest room temperature they're rated for, plus hard water scaling the ice maker and dispenser valves.
Kenmore Refrigerator Questions
Answers specific to Kenmore refrigerators. For anything else, ask when you book.
Ready to book?
Tell us the appliance, the brand and what it's doing, and we'll offer you the earliest appointment we have.
Find the model number on the label inside the fresh-food section. The three digits before the dot identify the maker: 106 for Whirlpool, 795 for LG and 253 for Frigidaire are common. Those digits decide which parts fit.
Ice maker icing is a known weak point on several French-door designs, including some LG-built Kenmore Elite models with the ice maker in the door. A failing ice compartment fan, a leaking seal or a frozen fill tube are common causes, and the prefix tells which parts apply.
Usually, yes. Most parts are the maker's own, so they're sourced through that platform's parts network rather than a Sears store. Older or Kenmore-only trim pieces can be harder to find.
Mostly which part failed. A defrost sensor, fan motor or start relay is a modest part, a control board costs more, and a sealed-system repair (a leak or a compressor) is the largest job because it involves brazing, evacuating and recharging. The price is quoted once the fault is confirmed, before any work.
Refrigerator brands we repair
Every Kenmore appliance we repair · Refrigerator repair for all brands