Kenmore Appliance Repair in North San Antonio

Kenmore doesn't manufacture anything itself. Different companies built Kenmore appliances over the years, so two models that look nearly identical can be completely different machines inside. The model number tells us whose engineering, and whose parts, we're dealing with.

Parts for Kenmore are made in volume and stocked by many suppliers, and most failures come down to an inexpensive part rather than a brand-specific assembly.

Control boards are the exception. A main board costs far more than a pump or a switch, and on an older appliance it can tip the decision toward replacing it.

Much of North San Antonio is single-story ranch housing from the 1950s through the 1970s, on slab foundations with attached garages. The laundry is usually in the garage or a utility room off the kitchen, the dryer vent often runs up through the attic, and many of these homes are on their third or fourth set of appliances.

The badge on the front matters less than you'd think. In North San Antonio, the ranch houses sit on big lots with long, single-story floor plans, so the laundry is often at the opposite end of the house from the kitchen and the dryer duct runs a long way through the attic before it reaches the roof or an outside wall, and a Kenmore appliance works with whatever drain, circuit, gas line and vent it is attached to.